Lightspeed flexcat - Student Group Speaker Controls and Connections

9
1. Overview 2. Initial Set-up 3. DaiIy Operation
4. Additional
Information
5. Maintenance &
Troubleshooting
6. Safety &
Specifications
1. POWER SWITCH: turns the
speaker power on or off. The
power shuts off automatically
when charging.
2. VOLUME: adjust the speaker
volume up or down.
3. REGISTER: press this button to
register a new group speaker.
The speaker comes pre-
registered with the base station.
This only needs to be activated
if the speaker is replaced for
service or an additional speaker
is added.
4. REGISTRATION IN PROGRESS:
this LED will turn yellow to
indicate the speaker is in process
of registering with the base
station.
5. SPEAKER “READY”: this green
LED will light to indicate it is
ready for operation. The link
will take several seconds to be
re-established each time it is
powered on or removed from
charger.
6. DESKTOP SPEAKER NUMBER:
this 7-segment LED indicates the
group # this speaker has been
registered to. This display should
match the sticker on the topside
of the speaker.
7. BATTERY COMPARTMENT:
remove screw and open to
replace rechargeable battery
pack.
STUDENT GROUP SPEAKER CONTROLS
AND CONNECTIONS
VOL
ON
REG
LINK
REGISTER
STATION
#
OFF
POWER
VOL
ON
REG
LINK
REGISTER
STA TION
#
OFF
POWER
1
6
7
3
4
2