8
1. Overview
2. Set Up & Use /
Daily Operation
3. Optional Accessories
4. Maintenance &
Troubleshooting
5. Warranty, Safety
& Specifications
REAR PANEL CONTROLS AND
CONNECTIONS
REGISTER
USB POWER
5V/0.2A
+
–
AUDIO IN BAL. AUDIO OUT
AUDIO OUT
MIC LINE
AUDIO OUT/DC IN
1. REGISTRATION: Press this button if
there is a new component, such as a
microphone, to be registered.
2. USB POWER INPUT: Plug the micro
USB end of the power cable into this
USB port.
3. AUDIO INPUT JACK: 3.5mm stereo
connector for connecting classroom
audio sources to be played through
audio system.
4. BALANCED AUDIO OUTPUT:
This output sends the audio from
Multimike to a balanced input on an
amplifier or mixer. (Recommended
for longer cable runs connected to a
balanced input).
5. AUDIO OUTPUT: This unbalanced
output sends the audio from
Multimike to an input on an
amplifier (Recommended for most
applications).
6. MIC/LINE LEVEL SWITCH: Changes
the audio output level from low (MIC
level) to high (LINE level). Desired
position depends on the input level of
the amplifier.
7. AUDIO OUT/DC IN: This RJ-45 jack
allows for a Cat 5 cable connection
to a Lightspeed 885 amplifier. This
connection sends audio to the 885
and receives DC power.
3
2
4
1
2
5
2
USB power adaptor and cable
2
7
2
6
To Next Page
Loading...
