Lightspeed Zulu - Connecting a previously paired Bluetooth device; Using Zulus Bluetooth features

January 2008 11
3. Follow menu prompts on your Bluetooth phone or device to direct it to look for other
Bluetooth devices.
4. Select ZULU_BT from the list of found devices.
5. When asked to enter a passcode or PIN, enter 0000.
Connecting a previously paired Bluetooth device
When you turn on Bluetooth mode, Zulu tries to reconnect to the most recently paired
phone or device. Most Bluetooth devices connect to Zulu automatically, but in some
cases, you may need to use the device’s menu to select ZULU_BT.
Using Zulu’s Bluetooth features
You can use Zulu’s Bluetooth buttons to perform several functions on your phone or
audio device. These functions vary depending on the Bluetooth profile supported by your
phone or device.
Some typical functions for a cell phone are:
■
Press the Bluetooth button once for voice dialing (if supported by your phone).
■
Press the Bluetooth button once to answer the phone when it rings.
■
Press the Bluetooth button once to disconnect from a call.
■
Press and hold the Bluetooth button for 2 seconds to redial the last number called.
■
Use the Bluetooth volume buttons (Zulu’s + and - buttons) to adjust volume.
To conserve Zulu’s battery power, turn off Bluetooth mode when not in use.
ZuluUG_online.book Page 11 Thursday, December 27, 2007 9:50 PM