WTR Series
Product Capabilities and Features
WTR Installation & Maintenance Manual 330-15000 • Revision A • August
2.4 Storage Procedure
NOTE: The following is our recommended storage procedure to retain maximum product
integrity during storage. Failure to comply with recommended procedure will void the
warranty.
Storage (less than 1 year)
Store actuators on wooden skids to protect the machined mounting flange. Place the wooden
skids containing the actuators in a clean, dry, protected warehouse. If the actuators must be
stored outside, they must be covered in polyethylene protection with silica gel crystals to
absorb moisture. If an electric actuator is attached to the WTR actuator, refer to the storage
procedures in its respective manual for appropriate storage procedures. Rotate input shafts
every three months to mix the lubricant.
2-3
To Next Page
Loading...
