Linak TECHLINE ELEVATE - LC3 IC - Maintenance; Repair; Main Groups of Disposal; Warranty

Lifting Column LC3 IC | 29
Maintenance
• The lifting column is a closed unit and therefore requires no internal maintenance
• To ensure that the pregreased inner and middle profile remains lubricated, the actuator must only be
washed down when the lifting column is fully retracted
• Inspect attachment points, wires, sliders, cabinet, and plug, as well as check that the lifting column
functions correctly
Repair
Only an authorised LINAK® service centre should repair LINAK actuator systems� Systems to be repaired
under warranty must be sent to an authorised LINAK service centre�
In order to avoid the risk of malfunction, all actuator systems repairs must only be carried out by an
authorised LINAK Service shop or repairer, as special tools and parts must be used�
If a system is opened by unauthorised personel there is a risk that it may malfunction at a later date�
Main groups of disposal
LINAK’s products may be disposed of, possibly by dividing them into different waste groups for recycling or
combustion�
We recommend that our product is disassembled as much as possible at the disposal and that you try to
recycle it�
Product Metal scrap Cable scrap Electronic scrap
Plastic recycling or
combustion
LC3 IC X X X X
Warranty
There is an 18 months’ warranty on TECHLINE products against manufacturing faults calculated from the
production date of the
individual products (see label)� LINAK’s warranty is only valid in so far as the equipment has been used and
maintained correctly and
has not been tampered with� Furthermore, the actuator must not be exposed to violent treatment� In the
event of this, the warranty will
be ineffective/invalid� For further details, please see standard terms of sale and delivery for LINAK A/S�
Note:
Only an authorised LINAK
®
service centre should repair LINAK actuator systems� Systems to be repaired
under warranty must be sent to an authorised LINAK service centre�
In order to avoid the risk of malfunction, all actuator repairs must only be carried out by an authorised LINAK
Service shop or repairer, as special tools and parts must be used�
If a system is opened by unauthorised personel there is a risk that it may malfunction at a later date�
The actuator is not to be opened by unauthorised personnel� In case the actuator is opened, the warranty
will be invalid�