Page 14 of 40
• After having activated the RF handset keys; the reset key must be released.
• If no RF handset keys are activated during the matching procedure; no changes are made in the ID memory of the TD3.
Start-up - How to install the RF handset:
HB12RF
HB22RF
The TD3 can accept commands from up to 2 RF handsets.
From the factory the TD3 cannot recognise any RF handsets at all and must be matched to the RF handset(s) by the end-user/
bed manufacturer before these can control the TD3 operation.
Conditions which must be fulfilled prior to activating the learning mode:
• Both the back and the leg actuators must be in the fully down position; if one or both actuators are NOT in the fully down
position; the matching procedure cannot be continued as now an ordinary reset down function is performed instead.
Thereafter, the reset key must be released and reactivated.
Activating the learning mode:
• Activate the reset key on the TD3 by using a pen or similar to keep the button pressed.
• Keeping the reset key activated; the RF handset(s) must be activated one at a time by pressing a random key on the RF
handset. The RF handset IDs are stored in the TD3 memory and at the same time, previous RF handset IDs are erased.
HC20RF
To Next Page
Loading...
