Page 19 of 40
Massage systems controlled by HB22RF2000
Usage:
Enter/exit massage command mode
Pressing this button will toggle the handset from controlling massage functions and bed adjustment. The mode in which the
handset is, is indicated by the LED at the top of the handset :
LED Flashing – handset is controlling massage functions
LED Off – handset is controlling bed functions
Pressing this button has no influence on the TWINDRIVE unit except for waking it up so that the response time to massage
commands is shorter.
If no button is pressed for 10 minutes, the control will automatically return to bed function (LED off).
Controlling the backrest massage motor
Keep the button pressed to adjust the intensity up or down (Left button up, right button down). Keeping the down button
pressed will turn the motor off when going below minimal intensity. The intensity can be controlled when running in a
massage program, but the massage program will be temporarily halted and both motors are run with currently chosen intensity
until the up/down button is released.
A short button press turns the backrest massage motor on or off (Left button on, right button off).
If the massage motor is turned on, which had previously been turned off by decreasing the intensity, it will start the massage
motor at the lowest configured intensity (set by the TD3 configuration).
Controlling the leg rest massage motor
Keep button pressed to adjust the intensity up or down (Left button up, right button down). Keeping the down button pressed
will turn the motor off when going below minimal intensity. The intensity can be controlled when running in a massage
program, but the massage program will be temporarily halted and both motors are run with currently chosen intensity until the
up/down button is released.
A short button press turns the leg rest massage motor on or off (Left button on, right button off).
If the massage motor is turned on, which had previously been turned off by decreasing the intensity, it will start the massage
motor at the lowest configured intensity (set by the TD3 configuration).
Controlling the massage program
A short press on left button turns on a massage program (wave, pulse etc.) or changes to next program if a program is already
activated. Starting a massage program always turns on both motors at current intensity.
A short press on the right button turns off both massage motors no matter if they are running in a massage program, or
separately.
Press and hold the left button to increase the speed of the pulses/waves or press and hold the right button to decrease the
speed of the pulse/waves.
Store and recall massage settings
When in massage mode, 2 massage settings can be stored.
To store the current active massage settings, press the “S” button followed by either the “1” or “2” button. To recall a
previous stored setting, press the “1” or “2” button.
This HB can be used together with the TD1-memory and TD32.
To Next Page
Loading...
Need help?
General
