LINDR CWP - Operation and Interconnection; Filling Tank and Connecting Exchanger; Putting Device into Operation

Dispense equipment for wine makers
9
12. PUTTING INTO OPERATION:
1. Fill up the tank with clean water (or antifreeze).
2. Connect the water inlet and outlet to the heat exchanger (not included).
3. Use the switch to set the mode of choice (cooling – heating).
4. Set the target water temperature.
5. Set the target temperature for pump regulation.
6. Check that all connections are leak-proof.
WARNING: If you discover a leak, turn o the device. Fix any leaks found on the tubing. If
a leak is found inside the device or you are unsure how to proceed, contact a service centre.
11. FILLING THE TANK AND INTERCONNECTING WITH EXCHANGER :
• Fill the plastic tank up to the MAX mark.
• Interconnect the appliance with the heat exchanger using speed ttings (heat exchanger
not included).
gure 9 A gure 9 B
WARNING: After connecting the heat exchanger and starting the pump, the water level in
the tank may drop, so check the level again or top up the water.
WARNING: Do not tamper with or move the device while it contains water. Doing so could
result in water overowing from the tank.
Pour the liquid here