Mode
On each PC, the mode must be set to Infrastructure.
SSID (ESSID)
This must match the value used on the wireless access
point.
The default value is LinksysSMB24G
for radio 1 and
LinksysSMB5G
for radio 2
.
Note—The SSID is case sensitive.
802.1x
Authentication
Each client must obtain a certificate for authentication for
the RADIUS server.
802.1x
Encryption
Typically, EAP-TLS is used. This is a dynamic key system,
so keys do NOT have to be entered on each wireless
station.
You can also use a static WEP key (EAP-MD5). The
wireless access point supports both methods
simultaneously.
RADIUS Server Configuration
If using WPA2-Enterprise mode, the RADIUS server on your network must be configured as
follows:
•
It must provide and accept certificates for user authentication.
•
There must be a client login for the wireless access point itself.
•
The wireless access point will use its default name as its client login name. (However, your
RADIUS server may ignore this and use the IP address instead.)
•
The Shared Key, set on the Security screen of the access point, must match the Shared
Secret value on the RADIUS server.
•
Encryption settings must be correct.
802.1x Server Setup (Windows 2000 Server)
This section describes using Microsoft Internet Authentication Server as the RADIUS server,
since it is the most common RADIUS server available that supports the EAP-TLS authentication
method.
The following services on the Windows 2000 Domain Controller (PDC) are also required.
•
dhcpd
•
dns
•
rras
106
To Next Page
Loading...
Need help?
General
Weight and Dimensions
