Encryption Settings
The encryption settings must match the access point’s on the wireless network you wish to join.
•
Windows XP will detect any available wireless networks, and allow you to configure each
network independently.
•
Your network administrator can advise you of the correct settings for each network.
802.1x networks typically use EAP-TLS. This is a dynamic key system, so there is no need
to enter key values.
Enabling Encryption
To enable encryption for a wireless network:
1.
Click on the Wireless Networks tab.
2.
Select the wireless network from the Available networks list, and click Configure.
3.
Select and enter the correct values, as advised by your Network Administrator.
For example, to use EAP-TLS, you would enable Data encryption, and click the checkbox
for the setting The key is provided for me automatically, as shown below.
122
To Next Page
Loading...
Need help?
General
Weight and Dimensions
