5.
Define the IP address range. Change the subnet mask if necessary. Click Next.
6.
Add exclusions in the address fields if required. If no exclusions are required, leave it
blank. Click Next.
7.
Change the Lease Duration time if preferred. Click Next.
8.
Select Yes, I want to configure these options now, and click Next.
9.
Enter the router address for the current subnet. The router address may be left blank if
there is no router. Click Next.
10.
For the parent domain, enter the domain you specified for the domain controller setup, and
enter the server's address for the IP address. Click Next.
11.
If you don't want a WINS server, just click Next.
12.
Select Yes, I want to activate this scope now. Click Next, then Finish.
125
To Next Page
Loading...
