Linksys LAPN600 - Page 26

22
Flow Control
Enable or disable flow control of the Ethernet port.
802.1x Supplicant
802.1x
Supplicant
Enable if your network requires this access point to use 802.1X
authentication in order to operate.
Authentication
This feature supports following two kinds of authentication:
• Authentication via MAC Address
Select this if you want to use MAC Address for authentica-
tion.
The access point uses lowercase MAC address for Name and
Password, like xxxxxxxxxxxx.
• Authentication via Name and Password
Select this if you want to use name and password for
authentication.
Name - Enter the login name. The name includes 1 to 63
characters. Special characters are allowed.
Password - Enter the desired login password. The password
includes 4 to 63 characters. Special characters are allowed.
Discovery Settings
Bonjour
Enable if administrator wants the access point to be discovered by
Bonjour enabled devices automatically. If VLAN is enabled, the
discovery packets will be sent out via management VLAN only. The
access point supports http and https services.
LLDP
Enable if administrator wants the access point to be discovered by
switch by LLDP protocol. Information such as product name, device
name, firmware version, IP address, MAC address and so on will be
advertised.
LLDP-MED
Enable if administrator wants the access point to be discovered by
switch by LLDP-MED protocol. Information such as product name,
device name, firmware version, IP address, MAC address and so on
will be advertised.