45
Workgroup Bridge Status
Status
Enable or disable Workgroup Bridge function.
Before configuring Workgroup Bridge, make sure all devices in
Workgroup Bridge have the following identical settings.
• Radio
• IEEE 802.11 Mode
• Channel Bandwidth
• Channel (Auto is not recommended)
Infrastructure Client Interface
SSID
Enter the name of the SSID to which Workgroup Bridge will connect.
Click Site Survey button to choose from the list. It's necessary for
Workgroup Bridge to connect to remote access point.
Remote MAC
Address
Normally, Workgroup Bridge connects to a remote access point by
matching SSID. When more than one remote access point have the
same SSID, Workgroup Bridge can connect to different remote access
points.
Optional: You can specify the MAC address of the remote access point
to limit Workgroup Bridge’s connection to a specific remote access
point.
The format is xx:xx:xx:xx:xx:xx.
VLAN ID
Enter the VLAN ID for Workgroup Bridge.
When VLAN function is enabled, Workgroup Bridge only forwards
packets with specified VLAN to remote access points.
The list is only applicable when VLAN function is enabled.
Security Mode
Select the desired mode from the list.
• Disabled
• WPA-Personal
• WPA2-Personal
To Next Page
Loading...
