22
Chapter 6: Set Up and Configure the Router
System Summary Tab
10/100 4-Port VPN Router
Block WAN Request: It shows the status (On/ Off) and hyperlinks to the Block WAN Request section on the General
page of the Firewall Tab.
VPN Setting Status
VPN Summary: It hyperlinks to Summary page of VPN Tab.
Tunnel(s) Used: It shows the number of Tunnels used.
Tunnel(s) Available: It shows the number of Tunnels available.
Current Connected (The Group Name of GroupVPN1) users: It shows the number of users.
Current Connected (The Group Name of GroupVPN2) users: It shows the number of users.
(If GroupVPN is disabled, it will show “No Group VPN was defined.”)
Log Setting Status:
It hyperlinks to the System Log page of Log Tab.
If you have not set up the mail server in Log Tab, it shows “E-mail cannot be sent because you have not specified
an outbound SMTP server address.”
If you have set up the mail server but the log has not come out due to Log Queue Length and Log Time Threshold
settings, it shows “E-mail settings have been configured.”
If you have set up the mail server and the log has been sent to the mail server, it shows “E-mail settings have
been configured and sent out normally.”
If you have set up the mail server and the log cannot be sent to mail server successfully, it shows “E-mail cannot
be sent out, probably use incorrect settings.”
To Next Page
Loading...
Need help?
General
