43
Chapter 6: Set Up and Configure the Router
VPN Tab - Gateway to Gateway
10/100 4-Port VPN Router
IP Only: If you select IP Only, only the specific IP Address that you enter will be able to access the tunnel. It’s the
IP Address of the remote VPN Router or device with which you wish to communicate. The remote VPN device can
be another VPN Router or a VPN Server. The IP Address will be the static, fixed IP only.
IP + Domain Name(FQDN) Authentication: If you select this type, enter the FQDN (Fully Qualified Domain Name)
and IP address of the VPN device at the other end of the tunnel. The FQDN is the host name and domain name for
a specific computer on the Internet, for example, vpn.myvpnserver.com. The IP and FQDN must be the same as
the Local Gateway of the remote VPN device, and the same IP and FQDN can be used only for one tunnel
connection.
IP + E-mail Addr.(USER FQDN) Authentication: If you select this type, enter the E-mail address and IP address of
the VPN device at the other end of the tunnel.
Dynamic IP + Domain Name(FQDN) Authentication: If you select this type, the Remote Security Gateway will be a
dynamic IP, so you don’t need to enter the IP address. When the Remote Security Gateway requests to create a
tunnel with the RV042, the RV042 will work as a responder. If you select this type, just enter the Domain Name for
Authentication, and the Domain Name must be the same as the Local Gateway of the remote VPN device. The
same Domain Name can be used only for one tunnel connection, and users can’t use the same Domain Name to
create a new tunnel connection.
Dynamic IP + E-mail Addr. (USER FQDN) Authentication: If you select this type, the Remote Security Gateway will
be a dynamic IP, so you don’t need to enter the IP address. When the Remote Security Gateway requests to create
a tunnel with the RV042, the RV042 will work as a responder. If you select this type, just enter the E-mail address
for Authentication.
Remote Security Group Type: Select the Remote Security Group that is behind the above Remote Gateway Type
you chose that can use this VPN tunnel. Remote Security Group Type may be a single IP address, a Subnet or an
IP range.
IP Address: If you select IP Address, only the remote computer with the specific IP Address that you enter will
be able to access the tunnel.
Subnet: If you select Subnet (which is the default), this will allow all computers on the remote subnet to
access the tunnel. Enter the remote IP Address and the Subnet Mask. The default Subnet Mask is
255.255.255.0.
IP Range: If you select IP Range, it will be a combination of Subnet and IP Address. You can specify a range of
IP Addresses within the Subnet which will have access to the tunnel.
To Next Page
Loading...
Need help?
General
