5-46
Linksys IP Phone Administrator Guide
Firmware Version 5.1
Chapter 5 Linksys IP Phone Field Reference
Ext Tab
Dial Plan
Note The following parameters do not apply to the SPA901.
The default dial plan script for each line is as follows:
(*xx|[3469]11|0|00|[2-9]xxxxxx|1xxx[2-9]xxxxxx|xxxxxxxxxxxx.). The syntax for a dial plan
expression is as follows:
If IP dialing is enabled, one can dial [user-id@]a.b.c.d[:port], where ‘@’, ‘.’, and ‘:’ are dialed by
entering *, user-id must be numeric (like a phone number) and a, b, c, d must be between 0 and 255, and
port must be larger than 255. If port is not given, 5060 is used. Port and User-Id are optional. If the
user-id portion matches a pattern in the dial plan, then it is interpreted as a regular phone number
according to the dial plan. The INVITE message, however, is still sent to the outbound proxy if it is
enabled.
Table 5-1 Dial Plan Script Syntax
Dial Plan Entry Functionality
*xx Allow arbitrary 2 digit star code
[3469]11 Allow x11 sequences
0Operator
00 International Operator
[2-9]xxxxxx US local number
1xxx[2-9]xxxxxx US 1 + 10-digit long distance number
xxxxxxxxxxxx. Everything else (Int’l long distance, FWD, ...)
To Next Page
Loading...
