Linksys SRW2008 User Manual

29
Chapter 5: Using the Web-based Utility for Configuration
Setup Tab - Network Settings
WebView Switches
PoE Information
Maximum Available Power. Indicates the maximum amount of power the device can supply.
System Operation Status. Indicates whether the PoE function is on or off.
Main Power Consumption. Displays how much power is currently used.
Setup Tab - Network Settings
The Network Settings screen allows you to assign DHCP or static IP settings to interfaces and assign default
gateways.
Identification
System Name. This field allows you to assign a system name.
System Location. This field is used for entering a description of where the Switch is located, such as 3rd floor.
System Contact. Enter the administrative contact person in this field.
System Object ID. The system object identifier is displayed here.
Base MAC Address. This is the MAC address of the Switch.
IP Configuration
Management VLAN. This drop-down allows you to select the Management VLAN.
IP Address Mode. This drop-down allows you to select Static or Dynamic IP address configuration.
Host Name. Enter the DHCP Host Name here.
IP Address. If using a static IP address, enter the IP address here.
Subnet Mask. Enter the subnet mask of the currently configured IP address.
Default Gateway. Enter the IP address of the Default Gateway.
Figure 5-3: Setup - Network Settings
NOTE: The PoE Information only appears on the summary screen of the SRW2008P and
SRW2008MP.

Linksys SRW2008 Specifications

General

Brand	Linksys
Model	SRW2008
Category	Switch
Language	English