Linksys SRW2016 User Manual

34
Chapter 5: Using the Web-based Utility for Configuration
Setup Tab - Network Settings
WebView Switches
Setup Tab - Network Settings
The Network Settings screen allows you to assign DHCP or static IP settings to interfaces and assign default
gateways.
Identification
System Name. This field allows you to assign a system name.
System Location. This field is used for entering a description of where the Switch is located, such as 3rd floor.
System Contact. Enter the administrative contact person in this field.
System Object ID. The system object identifier is displayed here.
Base MAC Address. This is the MAC address of the Switch.
IP Configuration
Management VLAN. This drop-down allows you to select the Management VLAN.
IP Address Mode. This drop-down allows you to select Static or Dynamic IP address configuration.
Host Name. Enter the DHCP Host Name here.
IP Address. If using a static IP address, enter the IP address here.
Subnet Mask. If using a static IP address, enter the subnet mask of the currently configured IP address.
Default Gateway. If using a static IP address, enter the IP address of the Default Gateway.
DNS Server. Enter the primary DNS Server information.
Click the Save Settings button to save your changes or click Cancel Changes to discard the information.
Figure 5-3: Setup - Network Settings

Linksys SRW2016 Specifications

General

Brand	Linksys
Model	SRW2016
Category	Switch
Language	English