Linksys SRW2024

8
Chapter 3: Connecting the Switch
Connecting the Switch
16- or 24-Port 10/100/1000 Gigabit Switch with WebView
8. Power on the network devices connected to the Switch. Each active port’s corresponding Link/Act LED will
light up on the Switch. If a port has an active Gigabit connection, then its corresponding Gigabit LED will also
light up.
If you will use the Switch’s console interface to configure the Switch, proceed to “Chapter 4: Using the Console
Interface for Configuration” for directions.
If you will use the Switch’s Web-based Utility to configure the Switch, proceed to “Chapter 5: Using the Web-
based Utility for Configuration.”