23
Chapter 5: Using the Web-based Utility for Configuration
Switch Conf. (Configuration) Tab - Interface Conf. (Configuration)
16- or 24-Port 10/100/1000 Gigabit Switch with WebView
Admin Status. Change the status of the port here.
Current Port Status. Displayed here is the status of the port.
Reactivate Suspended Port. If you want to reactivate a port that has been suspended, click the checkbox.
Operational Status. This indicates whether or not the port is active.
Admin Speed. Change the speed of the port here.
Current Port Speed. Displayed here is the current speed of the port.
Admin Duplex. Change the duplex mode here.
Current Duplex Mode. This is the duplex mode of the port.
Auto Negotiation. You can enable or disable the port’s Auto Negotiation feature.
Current Auto Negotiation. This is the current setting of the port’s Auto Negotiation feature.
Back Pressure. You can enable or disable the port’s Back Pressure feature.
Current Back Pressure. Displayed here is the status of the port’s Back Pressure mode.
Flow Control. You can enable or disable the port’s Flow Control feature.
Current Flow Control. This is the flow control status of the port.
MDI/MDIX. Select the Auto setting if you want the port to automatically detect the cable type. Select MDI if the
port is connected to an end station. Select MDIX if the port is connected to a hub or another switch.
Current MDI/MDIX. This is the current MDI/MDIX status of the port.
LA. This indicates if the port is part of a LAG.
Storm Control. You can enable or disable the port’s Storm Control setting.
PVE. You can enable a port to be a Private VLAN Edge (PVE) port if you want it to bypass the Forwarding Database
and forward all unicast, multicast, and broadcast traffic to an uplink, except for MAC-to-me packets.
Click the Submit button to save your changes.
To Next Page
Loading...
Need help?
General
