EasyManuals Logo

Linksys WAP4410N User Manual

Linksys WAP4410N
87 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
WAP4410N User Guide 32
The Administration - Management Tab
Configuring the Wireless-N Access Point
Wireless WDS Bridge
This option will let WDS APs communicate only with each other and don't allow wireless clients
or Stations to access them
Remote Wireless Bridges MAC Address—Enter the MAC addresses of the other APs in
the fields.
Wireless Client/Repeater
This option will let the Wireless Access Point to operate as a Client or Repeater Access Point,
sending all traffic received to another Access Point.
Allow wireless stations to associate—Enable or Disable the function.
Remote Access Point—Enter the MAC address and SSID of the desired Access Point or
click the Site Survey button to choose the Access Point from the available networks.
Wireless Monitor
When it is enabled, the Access Point can detect unauthorized (Rouge) Access Points on your
LAN
No Security—If checked, then any AP operating with security disabled is considered to
be a Rogue AP.
Not in Legal AP List—If checked, then any AP not listed in the Legal AP List is
considered to be a Rogue AP. If checked, you must maintain the Legal AP List
Define Legal AP—Click this button to open a sub-screen where you can modify the
Legal AP List. This list must contain all known APs, so must be kept up to date.
Change these settings as described here and click Save Settings to apply your changes, or click
Cancel Changes to cancel your changes. Help information is displayed on the right-hand side
of the screen, and click More for additional details.
The Administration - Management Tab
On this screen you can configure the password, Web Access, and SNMP settings.
Management
You should change the username/password that controls access to the Access Point’s Web-
based Utility to prevent unauthorized access.
Local AP Password
User Name—Modify the administrator user name. The default is admin.
AP Password—Modify the administrator password for the Access Points Web-based
Utility. The default is admin.
Re-enter to confirmTo confirm the new password, enter it again in this field.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Linksys WAP4410N and is the answer not in the manual?

Linksys WAP4410N Specifications

General IconGeneral
BrandLinksys
ModelWAP4410N
CategoryWireless Access Point
LanguageEnglish

Related product manuals