Chapter 6: Look after your printer
FA69315–3 English 57 Linx 5900 & 7900 Quick Start Guide
5. Press the Start Sequence key. The first Nozzle Clear sequence starts.
Figure 6-15. Nozzle Clear sequence
There are two progress bars:
• The upper bar shows the progress of each sequence.
• The lower bar shows the number of Nozzle Clear sequences that
have completed.
6. When the first sequence starts, turn the printhead upside down and
apply the solvent to the nozzle face (see Figure 6-16). The solvent
enters the nozzle:
Figure 6-16. Apply the solvent to the nozzle
68056
MIDI
Take care to build up
a good coating of
solvent on the nozzle
face, as shown here
To Next Page
Loading...
