Chapter 6: Look after your printer
Linx 5900 & 7900 Quick Start Guide 52 FA69315–5 English
6. Press the bottle to break the foil seal. Leave the bottle in position for a
minimum of 15 seconds to drain into the system.
7. Make sure that the bottle is empty and then remove the bottle. Refit
the filler cap to the printer.
NOTE: 7900 Spectrum printers only: a mixing sequence can start when
the ink is refilled. Wait until the mixing sequence has finished and
the status changes to “IDLE” before you try to print.
8. When the ink or solvent tank is full, the printer displays a confirmation
message.
Figure 6-8. Refill complete confirmation message
See ‘SureFill code messages’ on page 53 for more information about
SureFill® code messages.
Press the OK key to return to the SureFill page.
9. The SureFill page confirms that there are no current refill events.
Figure 6-9. SureFill page (No SureFill code required)
To Next Page
Loading...
