Lipco GSG-NV Series - Test Spraying and Liquid Preparation; Conducting Test Spraying

Operating Manual
Cross-flow fan unit type GSG-NV1 / 2
39 - 64
010980-26-E BA GSG-NV1_2 / 23.03.2012
17. Conducting test spraying
 Fill GSG-NV spray liquid tank partially with water, not pressur-
ized.
 Set the 3-way valve (Fig. 26) to
the “Suction tank” position.
The 3-way valve of the LIPCO
tank trailer is located under the
spray liquid tank.
3-way valve
Fig. 26
 Position: “Suction tank”
Liquid is pumped from the spray liquid tank / fresh
water tank to the nozzles in the tunnel walls.
 Switch on mixing unit and recycling injectors.
 Open required nozzles.
 Switch on power take-off shaft for pump and regulate to max.
540 RPM.
 Set the desired pressure at the control box and check whether
nozzles are spraying correctly.
 Conduct test spraying with water for nozzle setting on foliage
wall.