EasyManuals Logo

Lippert Components Smart Jack User Manual

Lippert Components Smart Jack
166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
Rev:11.08.19 Page 55 CCD-0001573-08
Hitch Recognition
1. To turn on the Auto Leveling Control Touch Pad, press both "UP" and "DOWN" arrows (Fig. 3B and 3C)
at the same time. The green indicator LED (Fig. 3A) will turn "On".
2. Press "HITCH HEIGHT" (Fig. 3E).
J. Rear jacks will retract.
K. The Power Tongue Jack will extend to the ground.
L. The front leveling jacks will retract.
M. The tongue jack will then adjust the height of the front of the trailer coupler to the point at which
the “AUTO LEVEL” button was most recently pressed.
1. The front of the trailer will raise to the height where the auto level sequence was started.
NOTE: If the front of the trailer was below level when the Auto Level process was initiated, the hitch
recognition feature will retract the rear jacks, but will not retract the Power Tongue Jack to lower
the trailer to the initial hitch height. This feature helps prevent injury and/or damage to anything
underneath the trailer.
2. Back the tow vehicle into position to align the tow vehicle hitch and trailer coupler with each other.
3. Press and hold the "DOWN" (Fig. 3C) arrow to retract the tongue jack until the coupler sets into
position on top of the tow vehicle hitch.
4. Latch the tow vehicle hitch and reconnect any wires, chains or sway controls that may be equipped
between the tow vehicle and trailer.
5. Press and hold the "DOWN" (Fig. 3C) arrow until the Power Tongue Jack is fully retracted.
6. Press "RETRACT ALL" (Fig. 3F) button. System will immediately retract all jacks.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lippert Components Smart Jack and is the answer not in the manual?

Lippert Components Smart Jack Specifications

General IconGeneral
BrandLippert Components
ModelSmart Jack
CategoryLifting Systems
LanguageEnglish

Related product manuals