Lippert Components Solera Classic - Installing Replacement Fabric

10
lci1.com 574 - 537- 890 0 Rev: 11.16.18
Solera
®
Classic Awning
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0001254
8. Place the removed assembly onto a level area.
9. Since the drive head assembly is still under tension, hold
the drive head assembly securely while someone securely
holds the idler head and roll tube.
10. Continuing to have the secure hold described in step 9,
remove the drive head assembly cotter pin.
FAILURE TO SUPPORT THE ROLL TUBE, FABRIC
AND DRIVE/IDLER HEAD ASSEMBLIES DURING
INSTALLATION MAY RESULT IN PERSONAL INJURY
OR PROPERTY DAMAGE.
FAILURE TO MAINTAIN CONTROL OF THE ROLL
TUBE, FABRIC AND DRIVE/IDLER HEADS MAY
RESULT IN PERSONAL INJURY OR PROPERTY
DAMAGE.
6. Remove the drive head assembly and idler head assembly
retaining fasteners from the outer arms to separate the
components (Fig. 14).
Fig.15
Fastener
7. Working together, remove the roll tube assembly (which
includes the drive and idler head assemblies) from the awning
rail and support arms by sliding the assembly along the
awning rail until clear.
11. While one person holds the roll tube, have another person
slowly rotate the drive head assembly clockwise to release
tension.
12. Mark the cam lock position on the roll tube with a non-
permanent marker.
13. Remove the three screws holding the drive head assembly
end cap on the roll tube and set the drive head assembly
aside.
14. Mark the roll tube grooves containing the polycords prior to
removing the fabric from the roll tube.
15. Remove the two screws holding the fabric in place on the
roll tube.
16. To remove the fabric, gently pull the roll tube from one end,
while another person holds the fabric in-place.
Installing Replacement Fabric
1. Unroll the replacement fabric so that the polycords are
parallel with the roll tube.
2. On a clean, level surface free of any debris that could
scratch or damage the roll tube, gently slide the roll tube onto
the two polycords of the fabric (Fig.15).
3. Center the fabric on the roll tube.
4. Apply the screws that were holding the polycords in place
on the roll tube.
Fabric
Polycord in
Roll Tube Channel
Slide
Fig.14