13
lci1.com 574 - 537- 8900 Rev: 03.16.18
Solera
®
Power Awning
Installation and Owner’s Manual
(For Aftermarket Application)
CCD-0001261
Solera Power Awning Troubleshooting (Continued)
Maintenance - Solera Awnings
Fabric Care
If the awning is retracted while wet, extend the awning
and let it dry as soon as conditions allow before again
retracting. This will help prevent the formation of mildew
and add to the life of the awning.
NOTE: Mildew does not form on the fabric itself, but on the
accumulated dust, dirt and grime.
Periodically clean vinyl or woven acrylic fabric using a
mixture of ¼ cup of dish soap and five gallons of warm
water.
1. Liberally apply the mixture on the top of the fabric and
retract the awning for five minutes.
2. Apply the mixture to the bottom of the fabric as well.
3. Extend the awning and hose off with fresh water.
4. Repeat if necessary.
5. Allow to dry before retracting.
What's Happening? What Should Be Done?
Awning works in opposite direction of what
switch shows.
Wires going to awning have been reversed or switched.
Reverse the wires.
Awning rolls up backward.
The awning fabric should always be above the roll tube.
However, if the extend switch is engaged too long or
EXTEND is hit inadvertently instead of RETRACT, the
awning will roll up backward. This is not a defect. To
correct the fabric orientation, press the RETRACT button.
The awning will then extend to its correct orientation and
normal operation can resume.