Lippert Components Solera - Parts Identification; Solera Power 18 V 69 Kit, Black; Solera Power 18 V 69 Kit, White; Common Parts

3
lci1.com 574 - 537- 8900 Rev: 03.16.18
Solera
®
Power Awning
Installation and Owner’s Manual
(For Aftermarket Application)
CCD-0001261
2. After determining the awning rail’s proper location, mark
its position with a non-permanent method of marking.
3. Seal the back of the awning rail.
4. Align the awning rail on the wall and secure with #10 x
¾" screws, using all fastener holes.
Awning Rail Installation
(if needed)
NOTE: Awning rail not included.
1. Position the awning rail along the line where roof and
wall meet OR:
A. For pitched awnings: A minimum of 6" above doors or
windows
B. For at awnings: A minimum of 2 ½" above doors or
windows
NOTE: The awning rail must be level and parallel with the
oor line of the unit (Fig.1).
Fig.1
oor line
front facing view
A
B
C
B
Letter Description
A Awning Rail
B Support Arm Assembly
C Roll Tube Assembly