Lippert Components Solera - Installation Preparation; Resources Required; Optional Upper Mounting Bracket Installation

4
lci1.com 574 - 537- 8900 Rev: 03.16.18
Solera
®
Power Awning
Installation and Owner’s Manual
(For Aftermarket Application)
CCD-0001261
Awning Installation
1. On the awning rail, mark the position of the centerlines
of the support arm assemblies. Make sure the support arm
assemblies will not interfere with any lights, vents or other
obstructions.
2. Using a non-permanent method of marking, mark a
perpendicular line from the awning rail down to the oor
line. This is the centerline of the support arm assembly
(Fig.2).
awning rail
oor line
Fig.2
Fig.3
awning width is from centerline to
centerline of support arm assemblies
3. Insert the drive head assembly shaft into the end cap
(Fig.3). Align the holes and secure with waxed screw.
Repeat process for idler head assembly at opposite end.
NOTE: Keep the head of the wax screw ⁄” from fastened
to avoid compromising the structural integrity of the wax
screw.