6
lci1.com 574 - 537- 8900 Rev: 03.16.18
Solera
®
Power Awning
Installation and Owner’s Manual
(For Aftermarket Application)
CCD-0001261
Securing The Fabric
1. Extend and retract the awning several times to make
sure the fabric is square on the roll tube.
2. Secure the fabric in the awning rail no more than
1" inside the edge of the fabric on both ends using a
#6 x ½" hex head screw.
3. Install the screw down through the awning rail into the
fabric and the polycord (Fig.8).
Fig.7
possible
fastener
locations
10. Cut the zip ties and connect the wires from the drive
head assembly to a power source and run the awning
halfway out.
11. Remove the wire cover to expose the fastening points.
12. Install the remaining two #14 x 1 ¼” screws at any of
the three locations shown in the center of the support arm
(Fig. 7).
13. Repeat this process for the other side of the awning
assembly.
Fig.8
awning rail
1"
fabric stitching
To Next Page
Loading...
