Rev: 05.26.23 Page 15 CCD-0007708
Screens
The primary features are shown on three different screens: The ARRIVAL SCREEN, CAMPING SCREEN, and
DEPARTURE SCREEN (Fig. 15). For convenience, only the controls primarily used during each phase of
camping are shown. To prevent accidental operation, certain controls are grayed-out until other controls
have been used.
Fig. 15
Arrival Camping Departure
Zero Point Calibration
The Zero Point is the programmed point that the trailer will return to each time the Auto Level feature is
used. The BaseCamp Hydraulic Leveling System controller is shipped with a programmed level zero point.
Basic Jack Operation
1. Landing Gear
A. Landing gear jacks can be operated any time the system is on, but not in AUTO MODE. Press and
hold the Extend Landing Gear button (Fig. 15A) so that both the front or landing gear jacks can be
extended.
NOTE: The Retract button will be grayed out (Fig. 15B) until the landing gear jacks have been extended.
B. Press and hold the Retract button to retract the landing jacks together.
2. All Jacks
A. All jacks operate when the system is performing an Auto Operation such as Auto Level, Return to
Hitch Height, or Retract All.
B. In Manual Mode, the corner jacks can be operated independently or in pairs. Middle rear jacks
operate in unison with the same-side rear jack.
NOTE: The default is mode is Auto Operation. Manual Mode can be selected through the Options (Fig. 15C)
menu.
B
A
C
To Next Page
Loading...
