Rev: 05.26.23 Page 11 CCD-0007708
Controller
NOTE: The BaseCamp Hydraulic Leveling System wiring is basically a plug and play system. The kit should
include harnesses for the entire system.
NOTE: The compartment where the controller will be installed must be protected from the elements and
the controller must be installed in compliance with RVIA Gas Codes, as the controller connections
are not spark-proof.
1. Using four #8 x 1" wood screws (Fig. 9B), attach the controller (Fig. 9A) to the compartment ceiling.
A. Controller must be mounted with the label facing down (Fig. 9C) from a surface that is level with
the horizontal plane of the chassis.
B. Controller must be mounted with the arrow facing the front of the trailer (Fig. 9D).
C. Connect all jack harnesses to the appropriate connectors on the controller. See Wiring Diagram.
A
B
Fig. 9
D
C
To Next Page
Loading...
