Lippert Basecamp - Troubleshooting; Manual Override - Jacks; Manual Override - Power System

Rev: 05.26.23 Page 8 CCD-0007708
Fig. 6
Manifold
B
C
D
E
Power Unit
1. The power unit mounting location was determined when the trailer was first inspected. Mount the
power unit (Fig. 6) to the back or side wall of the front compartment in the position you previously
determined using six (6) self tapping screws.
2. Attach hoses to fittings at manifold (Fig. 6).
A. Attach landing gear orange extend hose (Fig. 6A).
B. Attach landing gear black retract hose (Fig. 6B).
C. Attach roadside rear jacks orange extend hose (Fig. 6C).
D. Attach curbside rear jacks orange extend hose (Fig. 6D)
E. Attach rear jacks black retract hose (Fig. 6E).
A