Rev: 05.26.23 Page 2 CCD-0007708
TABLE OF CONTENTS
Introduction 2
Additional Information Sources 2
Component Description 3
Safety 3
Resources Required 4
Installation 4
Mid and Rear Jacks 4
Front Landing Gear 7
Power Unit 8
Hydraulic Hoses 9
Controller 11
Touchscreen 12
LED Light Harness 13
System Wiring Requirements 13
Purging Hydraulic System 14
Operation 14
Prior to Operation 14
Touchscreen Operation 14
Screens 15
Zero Point Calibration 15
Basic Jack Operation 15
Troubleshooting 16
Manual Override 16
Error Codes 17
Wiring Diagram 20
Plumbing Diagram 21
Introduction
Please read and study the operating manual before operating the leveling system. The BaseCamp™
Hydraulic Leveling System includes six points of contact utilizing aluminum jacks and multi-valve system. A
12V DC electric motor drives a hydraulic pump that moves fluid through a system of hoses, fittings and jacks
to level and stabilize the trailer. The hydraulic pump should be isolated from any power source through a
50 - 100 amp protection per RVIA Standards and OEM Requirements. Mechanical portions of the BaseCamp
Hydraulic Leveling System are replaceable. Contact Lippert to obtain replacement parts.
Additional Information Sources
Additional information about this product can be obtained from lci1.com/support or by downloading the
free LippertNOW app. The app is available on Apple App Store® for iPhone® and iPad® and also on Google
Play™ for Android™ users.
App Store®, iPhone®, and iPad® are registered trademarks of Apple Inc.
Google Play™ and Android™ are trademarks of Google Inc.
NOTE: Images used in this document are for reference only when assembling, installing and/or operating
this product. Actual appearance of provided and/or purchased parts and assemblies may differ.
For information on the assembly or individual components of this product, please visit:
https://support.lci1.com/basecamp-leveling.
To Next Page
Loading...
