Rev: 05.26.23 Page 19 CCD-0007708
Error Message What Should Be Done?
Touch Screen Power
Failure
Remove the touchscreen bezel. Remove mounting screws. Check
connector on touchscreen for damage. Check for broken, cut, crushed, or
detached wires in wire harness. Reconnect cable and remount touchscreen
and bezel. Locate leveling controller. Check connector on controller for
damage. Reconnect cable and remount touchscreen and bezel. Attempt to
use interface.
Hitch Point Not Set
Adjust the RV manually to connect to your vehicle. The hitch point is saved
at the start of auto level.
Front Jacks Cannot
Extend Further
Return the RV to hitch-height. Position tow-vehicle to re-hitch. Lower RV
onto hitch, and then, retract all jacks. Re-position RV in a location that
appears more level and attempt to level your RV again.
Action Prevented
The attempted action is not allowed due to a device lockout being active.
Disconnect from your tow vehicle and try again.
Leveler Not Found
The leveling controller is not detected. Check the controller for
disconnected cables.
To Next Page
Loading...
