Lippert Solera 3000 Series - Operation; Extending the Awning

10
CCD-0001262
3000 Series 12V
Power Awning
LED Lights
Aftermarket Manual
(For Aftermarket Applications)
lippert.com 432-LIPPERT (432-547-7378) Rev. 09.23.24
Operation
NOTE: Some units may not use the Lippert switch (Fig. 14).
Extending the Awning
1. Verify the RV battery is fully charged and connected to
the electrical system.
2. Locate the locking latch on the side of the support arm,
if equipped, and unlock the latch.
NOTE: This latch is optional and may or may not be
installed on one or both support arms.
3. Press and hold EXTEND (Fig. 14A) until the awning is
extended completely.
fabric polycord
roll tube
fabric
awning head
valance
Fig. 15
Fig. 14
A
B
NOTE: Extension is considered complete when the fabric
is completely unrolled, the valance is hanging down from
the roll tube and a section of the roll tube is exposed
(Fig. 15).
IMPACT OR CRUSH HAZARD - PITCH MUST BE
SET TO LOWER ONE SIDE OF THE AWNING
AFTER THE AWNING IS EXTENDED. FAILURE TO
SET PITCH COULD LEAD TO WATER, SNOW OR
DEBRIS ACCUMULATING ON THE AWNING FABRIC,
WHICH COULD CAUSE THE AWNING TO MOVE
UNPREDICTABLY, BECOME UNSTABLE, AND BEND
OR COLLAPSE CAUSING DEATH OR PERSONAL
INJURY OR PROPERTY DAMAGE.
IMPACT OR CRUSH HAZARD - DO NOT ADJUST
PITCH MANUALLY IF THERE IS ALREADY POOLING
WATER, SNOW OR DEBRIS ON THE AWNING FABRIC.
KEEP THE AWNING ARM AREA CLEAR OF PEOPLE
AND OBJECTS WHEN IN OPERATION. FAILURE TO
HEED THESE WARNINGS COULD CAUSE SEVERE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
TYING DOWN THE ROLL TUBE ONCE THE AWNING
IS EXTENDED WILL NOT ALLOW THE FREE-
FLOATING SUPPORT ARMS TO WORK AS DESIGNED
AND MAY CAUSE DAMAGE TO THE AWNING OR
UNIT.