9
CCD-0001262
3000 Series 12V
Power Awning
LED Lights
Aftermarket Manual
(For Aftermarket Applications)
lippert.com 432-LIPPERT (432-547-7378) Rev. 09.23.24
LED Light Rail
NOTE: Solera® Power Awning must be installed prior to
LED Light Rail installation.
1. Seal the back of the LED light rail.
2. Mount the LED light rail (Fig. 12B) directly below the
awning rail (Fig. 12A) and secure to the side of the unit.
3. Remove the wire covers in the drive side mount arm.
4. Route the light wire over the top of the upper brackets
on the mount arm and run the light wire down through the
support arm assembly in the same manner as the motor
wire (Fig. 12C).
A
B C
Fig. 12
Seal Wall Penetrations
1. Seal all fastener locations and wire penetrations to
protect against water intrusion (Fig. 13).
2. Reinstall all wire covers into the support arm
assemblies.
Fig 13
To Next Page
Loading...