4
CCD-0001262
3000 Series 12V
Power Awning
LED Lights
Aftermarket Manual
(For Aftermarket Applications)
lippert.com 432-LIPPERT (432-547-7378) Rev. 09.23.24
Installation
1. On the awning rail, mark the position of the centerlines
of the support arm assemblies. Make Sure that the
support arm assemblies will not interfere with any lights,
vents or other obstructions.
2. Using a non-permanent method of marking, mark a
line. This is the centerline of the support arm assembly
(Fig.2).
3. Insert the drive head assembly shaft into the end cap
(Fig.3). Align the holes and secure with waxed screw.
Repeat process for idler head assembly at other end.
NOTE:
to avoid compromising the structural integrity of the wax
screw.
awning rail
Floor Line
awning width is from centerline to
centerline of support arm assemblies
Fig. 2
Fig.3
NOTE: For awnings exceeding 21 feet in length, a center support must be installed. Locate the center of the awning
(between the perpendicular marks previously made corresponding to the center of the support arm assemblies) and make
a mark. Once the awning has been installed, refer to TI-303 Solera® Awning Center Support for detailed instructions
covering center support installation.
To Next Page
Loading...