Lippert Solera 3000 Series - Manual Override

12
CCD-0001262
3000 Series 12V
Power Awning
LED Lights
Aftermarket Manual
(For Aftermarket Applications)
lippert.com 432-LIPPERT (432-547-7378) Rev. 09.23.24
Manual Override
3. When the awning is completely retracted, replace the
rubber grommet in the drive head assembly (Fig. 20A).
NOTE: The motor’s internal drive system prevents the
awning from moving (extend or retract) on its own. If the
motor is damaged or disabled, make sure to secure the
awning in the retracted position with a strap around both
the outer arm and the mount arm (Fig. 22A) before the
manual override nut is released.
Fig. 20
DURING INCIDENTS OF HIGH WIND, HEAVY RAIN
OR EXTENDED TIME AWAY FROM THE UNIT,
IT IS ADVISABLE TO RETRACT THE AWNING
COMPLETELY TO PREVENT DAMAGE TO THE
AWNING AND THE UNIT.
In the event of power loss or motor failure, the awning can
be extended and retracted manually. Perform the following
procedure to manually retract the awning.
NOTE: This procedure may also be performed to extend or
retract the awning in the event of dry camping or camping
without a battery.
1. Remove the rubber grommet (Fig. 20A) from the drive head
assembly, exposing the manual override nut on the motor.
Fig. 21
NOTE: The drive head assembly is always located on
the right side of the awning as it is viewed from outside
of the unit.
A
Fig. 22
2. ” socket and cordless or electric drill or screw
gun, spin the manual override nut clockwise to extend or
counterclockwise to retract the awning (Fig. 21A).
NOTE: Use caution when retracting the awning manually.
The use of a step stool or ladder may be required to
completely retract the awning.
A