6
CCD-0001262
3000 Series 12V
Power Awning
LED Lights
Aftermarket Manual
(For Aftermarket Applications)
lippert.com 432-LIPPERT (432-547-7378) Rev. 09.23.24
10. Cut the zip ties and connect the wires from the drive
head assembly to a power source and run the awning
half way out. Remove the wire cover to expose the
fastening points. Install the remaining two #14 x 1 ¼
screws at any of the three locations shown (Fig.7) in the
center of the support arm. Repeat this process for the
other end of the awning assembly.
possible
fastener
locations
Fig. 7
Fig. 8
Securing The Fabric
Secure the fabric with to the awning rail using ONE of
the two options listed below. In option 1 the screw will
go through the fabric, awning rail, and polycord, while in
option 2, the screw will only go through the awning rail
and polycord.
Option 1
Secure the fabric (Fig. 8A) in the awning rail (Fig. 8B) no
more than 1" inside the edge of the fabric on both ends
using an OEM supplied #6 x ½" hex head screw (Fig. 8C).
Install the screw (Fig. 8C) down through the awning rail
(Fig. 8B) into the fabric (Fig. 8A) and the
polycord (Fig. 8D).
Option 2
Secure the fabric (Fig. 8A) in the awning rail (Fig. 8B) no
more than ¼" outside the edge of the fabric on both ends
using an OEM supplied #6 x ½" hex head screw (Fig. 8E).
Install the screw (Fig. 8E) down through the awning rail
(Fig. 8B) and polycord (Fig. 8D).
NOTE: When choosing option 2 for installation, polycord
MUST extend past the fabric more than ¼" to allow it to be
secured by the screw, and screw must fully penetrate and
secure polycord when installed.
Outer edge of fabric
B
D
A
¼”
E C
1”
OR
To Next Page
Loading...