8
CCD-0001262
3000 Series 12V
Power Awning
LED Lights
Aftermarket Manual
(For Aftermarket Applications)
lippert.com 432-LIPPERT (432-547-7378) Rev. 09.23.24
LED Light Installation
Fabled (Fabric LED)
1. Depending on top wire or bottom wire installation,
remove the wire covers in the drive mount arm.
2. If bottom installation, take the LED power wire (Fig. 10A)
from the light track and run it down the drive arm. Make
sure to run the wires over the center pin of the drive mount
arm.
3. Connect the LED power wire to the unit’s power source.
Make sure the black wire is connected to a ground and the
red wire is connected to 12V DC power source.
4. Connect an appropriate-size fuse to protect all wiring
going to the light, that meets or exceeds RVIA standards.
Fig. 10
A
LED Roll Tube
The awning fabric has a power wire (Fig. 11A) sewn into the
hem. The power wire is connected to the LED light in the
roll tube prior to the end cap being installed on the roll tube
by LCI.
1. Connect the wires from the roll tube end cap to the wires
in the hem of the fabric.
2. Depending on top wire or bottom wire installation,
remove the wire covers in the drive mount arm.
3. If bottom installation, take the LED power wire (Fig. 10A)
sewn into the hem of the fabric and run it down the drive
arm. Make sure to run the wires over the center pin of the
drive mount arm.
4. Connect the LED power wire to the unit’s power source.
Make sure the black wire is connected to a ground and the
red wire is connected to 12V DC power source.
5. Connect an appropriate-size fuse to protect all wiring
going to the light, that meets or exceeds RVIA standards.
Fig. 11
A
LED light strip
To Next Page
Loading...