14
CCD-0001262
3000 Series 12V
Power Awning
LED Lights
Aftermarket Manual
(For Aftermarket Applications)
lippert.com 432-LIPPERT (432-547-7378) Rev. 09.23.24
What’s HappeningWhat’s Happening Why?Why? What Should Be Done?What Should Be Done?
Awning doesn’t close all the way. Normal condition. The awning is considered completely closed as long as
the outer arm is overlapping the mount arm. This overlap
can vary.
Ostructions in the support
arm assemblies.
Clear any obstructions from the support arm
assemblies preventing the awning from closing.
Fabric not square with roll
tube.
Verify the fabric is square from unit to roll tube and is
rolling up straight on the roll tube.
Awning runs slow.
retract and extend speeds.
The awning will run slower during retract than extend.
Retract is approximately 35 seconds while extend is
approximately 27 seconds on a fully-charged battery.
Low voltage between unit
and awning wire.
Make sure there are 12 volts where the unit wire
meets the awning wire during retract.
Pitch arms are bent in an
upward direction.
Make sure the pitch arms are not bent in an upward
direction.
Poor switch ground
connection to battery or
chassis.
Make sure the ground wire before the switch has a
good connection to the battery or chassis.
Awning seems to wobble when
extending or retracting.
Loose support arm
assembly bolts.
Make sure support arm assembly bolts are tight.
Improperly seated end
caps.
Make sure end caps are properly seated on roll tube.
Bent head shaft. Make sure shaft exiting the head and going to the end
cap isn’t bent.
Wall mount not secured. Make sure wall mount is secured to the wall.
Support arm assemblies
are bent.
Make sure no part of the support arm assemblies are
bent.
Wear collar spacers are
not properly located in the
support arm assemblies.
Make sure the wear collar spacers are all properly
located in the support arm assemblies.
Awning works in opposite direction
of what
switch shows.
Reversed or switched
wires.
Wires going to awning have been reversed or
switched. Reverse the wires.
Awning rolls up backwards Awning fabric does not roll
up above the roll tube.
The awning fabric should always be above the roll
tube. However, if the extend switch is engaged too
long or extend is hit inadvertently instead of retract,
the awning will roll up backward. This is not a defect.
To correct the fabric orientation, press the retract
button. The awning will then extend to its correct
orientation and normal operation can resume.
Lights won’t work. Resettable fuse not reset.
seconds to reset.
Low voltage on red wire
goig to the light.
Make sure to have 12 volts to the red wire on the light.
To Next Page
Loading...