*1. Please remove DC+(+1/+2) jumper when installing DC reactor. Besides, 400V F6/F7 DC reactor are (P/DC+). Besides, 200V F1-
F2 model no built-in DC reactor.
*2. When using braking resistor, please ensure stall prevention function is off. Besides, 400V F6/F7 braking resistor are (DC+/DC-).
*3. J5 or J4 is port of optional communication card. Optional communication card is planning. 200V F1-F2 is J14. 200V F3-F4 and
F3-F7 is J5.
*4. Multi-function digital input S1~S6 can be switched between Sink(NPN) or Source (PNP) mode. Default : Sink(NPN) mode.
*5. Switch A2 is used to set analog input as voltage input or current input.
*6. AC is common terminal of analog signal (Analog Common).
*7. Pulse input and digital inputs share the same terminal (5.5 k W or less shared S4, 7.5 k W more common S7).
*8. RJ45 is the communication port of RS-485.
*9. Analog output is used to connect frequency meter, current meter, voltage meter and power meter
*10. This manualincludes the blueprint of our products in the future. For more precise specifications, please refer to the user
manual. If you have any question, please contact our authorized distributors or LITE-ON.
To Next Page
Loading...
