Note
*1. When using braking resistor, please ensure stall prevention function is off.
*2. Multi-function digital input S1~S3 can be switched between Sink(NPN) or Source(PNP) mode. Default: Sink(NPN) mode.
*3. Switch A2 is used to set analog input as voltage input or current input.
*4. AC is common terminal of analog signal (Analog Common).
*5. Pulse input and digital inputs share the same terminal (5.5 k W or less shared S4).
*6. Pulse output and digital outputs share the same terminal (5.5 k W or less shared DO).
*7. RJ45 is the communication port of RS-485.
*8. Analog output is used to connect frequency meter, current meter, voltage meter and power meter.
*9. This manual includes the blueprint of our products in the future. For more precise specifications, please refer to the user manual.
If you have any question, please contact our authorized distributors or LITE-ON.
To Next Page
Loading...
