69
4.4.4 RS-485 Communication Termination ON / OFF Switch
The default of termination resistor for RS-485 communication is OFF. Switch it to ON when the drive
is the last in a series of slave drives. Set this termination resistor on DIP switch RS485 illustrated in
Figure 4.4.4. Besides, 400V F1-F2 model don’t have termination resistor
Figure 4.4.4 DIP Switch RS-485 Termination Resistor
4.5 Connection to PC
The drive is equipped with a RJ45 port. The drive can connect to a PC through RJ45 cable to manage parameter settings
using LiteOn PC software.
.
Figure 4.5 Connection to PC
To Next Page
Loading...
