4
Press to select a suitable TV system, then
press ENTER.
The DVD recorder will start searching for the
channel signal.
5
When the scanning process is completed, press
to select your desired option, then press
ENTER.
▌ OK
If the scanning result is what you want, press to
select ‘OK’, then press ENTER.
▌ Scan Next
If the scanning result is not what you want, press
to select ‘Scan Next’, then press ENTER.
The DVD recorder will then start searching for the
next available channel frequency.
▌ Cancel
If you decide not to make any change, press to
select ‘Cancel’, then press ENTER.
6
To apply the frequency setting to other channels,
repeat steps 1-5.
7
When completed, press to select ‘Exit’ or
another option to continue, then press ENTER.
ShowView
Programming
System
The ShowView programming system is a specially-de-
signed feature for recording TV programs. The system
greatly simplifi es the timer recording process, as it
does not require users to enter program information,
such as date, channel number and start/end time,
which are all contained in the ShowView programming
numbers. You can complete the timer recording setup
simply by inputting the ShowView number, which can
be found in most newspapers, TV listing magazines or
online sources.
As channel numbers may vary depending on
where you live, it is suggested that you build up
a matching channel list when you fi rst set up
the DVD recorder. This process will help you to
make use of the ShowView system for future
timer recording settings.
1
Press TV(MODE) or press SOURCE to set ‘TV’ as
the signal source.
By default, pressing TV(MODE) allows you to switch
to TV directly. However, if you have activated the
‘SCART Bypass’ mode earlier through Setup menu,
you can only press SOURCE to switch to TV.
If you press SOURCE, you may need to press the
button more than once to switch to ‘TV’.
2
Press EDIT to display the Channel Editor menu.
3
Press to select a TV channel, then press
ENTER.
4
Press to select ‘GCN’, then press ENTER.
A pop-up box for entering GCN will appear.
5
Press or number buttons (0-9) to enter
the GCN (Guide Channel Number), which is the
channel number used by the ShowView system,
then press ENTER.
6
To set GCN for other channels, repeat steps 3-5.
7
When completed, press to select ‘Exit’,
then press ENTER.
To Next Page
Loading...
