47
Recording
Recording from TV
Before you start
► Check whether you have switched your TV’s
input source to corresponding option (e.g.
VIDEO 1, LINE 2, etc.), so that signal from the
DVD recorder can appear on screen. For further
information, please check the instruction manual
offered by your TV manufacturer.
► Check whether you select and insert a record-
able disc. If you use blank DVD-RW discs, you
will need to format the discs before recording.
Follow the instructions on screen to complete the
process.
Disc Information (p.6)
► Check whether there is enough space on the disc
or on the hard drive.
► Check whether the channel scanning process for
your TV is completed.
Setup Menu (Tuner) (p.24)
1 Select a recording mode.
Press SETUP to display the Setup menu.
Press to select ‘Recording/Playback’, then
press or ENTER.
Press to select ‘Recording Mode’, then press
ENTER.
Press to select a recording mode, then press
ENTER.
HQ
SP
LP
EP
SLP
Recording / Playback
When completed, press SETUP to exit the Setup
menu.
2 Select the target medium to save the recording.
▌ HDD
Press HDD/DVD to switch to HDD.
▌ Disc
Press OPEN/CLOSE to open the disc tray.
Carefully place the disc in the tray with the label side
facing up, then press OPEN/CLOSE.
3 Press TV (MODE) or SOURCE to select ‘TV’ as the
signal source.
By default, pressing TV (MODE) allows you to switch
to TV directly. However, if you have activated the
‘SCART Bypass’ mode earlier through Setup menu,
you can only press SOURCE to switch to TV.
If you press SOURCE, you may need to press the
button more than once to switch to ‘TV’.
4 Press CH+ and CH- to select desired channel.
You can press number buttons (0-9) to select a chan-
nel. When completed, press ENTER for confi rmation.
(For Channel 6, press 6, then ENTER. For Channel
55, press 5, 5 and ENTER.)
5 Press RECORD to start recording.
6 Press PAUSE/STEP to pause recording
Press STOP to stop recording.
7 Press RECORD again if you need to start
another recording session.
When the DVD recorder is switched on during
recording, you can only view the recorded channel
on screen. If you would like to watch a different TV
channel, you can do so by switching your TV’s input
source to tuner device (e.g. antenna, cable box
or satellite box). This will not affect the recording
already in progress. For further information on how to
change the input source, please check the instruction
manual offered by your TV manufacturer.
To Next Page
Loading...
