A-B Repeat
1
Press to select ‘A-B Repeat’, then
press ENTER to go to the sub-menu.
2
When playback reaches the beginning of your
desired session, press to select ‘Point A’,
then press ENTER.
3
When playback reaches the end of the desired
session, press to select ‘Point B’, then
press ENTER.
Repeat from point A to point B will start.
4
To cancel the repeat mode, press to select
‘Cancel’, then press ENTER.
5
Press NAVI. again or repeatedly press to exit
the Navigation menu.
Note
• If you exit the function, setting only point A, the
preset point A will still be valid when you enter
the ‘A-B Repeat’ function next time.
• The ‘Cancel’ function is only available when
both point A and point B are set.
• The ‘A-B Repeat’ setting will be canceled when
you bring the program to a marked stop or a full
stop.
Subtitle
Some pre-recorded DVD discs have more than one
subtitle language. The language initially selected
for playback will be the one you select when you
fi rst set up the DVD recorder. Nevertheless, you
can change the subtitle language of the disc at any
time.
Setting Language (p.17)
1
Press to select ‘Subtitle’, then press
ENTER to go to the sub-menu.
All the available subtitle languages will be displayed.
2
Press to select a subtitle language, then
press ENTER.
3
Press NAVI. again or repeatedly press to exit
the Navigation menu.
Note
• This function will be disabled, if not available.
To Next Page
Loading...
