LiteOn LVW-5115GHC+ - Overwriting a Title; Protecting a Title

65
Editing
If you decided not to change the original title
name, press  to select ‘Cancel’, then
press ENTER.
10
When completed, press  to select
‘Finish’, then press ENTER.
Note
• The entry bar
CANNOT be left blank. If such
a condition occurs, you will not be able to exit
the keypad screen. Please follow the instruction
given in the pop-up dialogue box, and go back to
complete the process.
• Please pay extra attention when you name a title,
as the DVD recorder does not inhibit you from
entering same names for different titles.
Protecting a Title
You can protect the title from accidental erasure or
unplanned editings when you activate the ‘Protect’
function. When the function is switched ‘On’, the
title CANNOT be edited or erased. If you need to
edit it, you must unlock the fi le fi rst.
1
Press OPEN/CLOSE to open the disc tray.
2
Carefully place the disc on the tray with the
label side facing up, then press OPEN/
CLOSE.
3
A disc menu will appear. Press  to
select the title you would like to edit, then
press ENTER.
4
Playback will then start.
5
Press EDIT to display the Edit menu.
6
On the Edit menu, press  to select
‘Protect’, then press ENTER to switch on or
off the ‘Protect’ function.
Editing_01_02
7
Press  to select ‘Exit’, then press ENTER
to exit the setting.
8
If you switch on the function, a lock icon will
be shown next to the protected title on the disc
menu.
Editing_01_03
Overwriting a Title
When you apply the function to a title, it will be
deleted and overwritten when you record new
title/program next time.
1
Press OPEN/CLOSE to open the disc tray.
2
Carefully place the disc on the tray with the
label side facing up, then press OPEN/
CLOSE.
3
A disc menu will appear. Press  to
select the title you would like to edit, then
press ENTER.
4
Playback will then start.
5
Press EDIT to display the Edit menu.
6
On the Edit menu, press  to select
‘Overwrite’, then press ENTER to switch on
or off the ‘Overwrite’ function.
Editing_01_04
7
Press  to select ‘Exit’, then press ENTER
to exit the setting.