LNTECH SLA-3

9
【
Adjustment Mode
】
This mode applied to the condition that initially install the SLA-3 or
move the emitter/receiver in operation, all laser beams turn ON, output
OSSD1,OSSD2 turn OFF, when the beams are not aimed at the
receiver properly, E1,E2,E3 indicators "ON", otherwise the indicators
are "OFF" and no ashing means promper alignment.
【
Flat Bending Mode
】
Process the at material in the mode, E1,E2,E3 beams all work
normally, when any beam is blocked the output OSSD1,OSSD2 "OFF"
during the high speed closing.
Mode Change Access(key)
Mode Option Button
back of receiver
Fig.2-1 Time Diagram of Flat Bending Mode